Ubiquiti Enterprise Fortress Gateway (EFG) vs Juniper Networks SRX4600: Specs & Price Comparison

Ubiquiti Enterprise Fortress Gateway (EFG)

★ 4.9 Value Score

Firewall Throughput: 23.5 Gbps (routing, iPerf3, DHCP WAN)
Threat Prevention Throughput: 12.5 Gbps (IDS/IPS)
IPsec VPN Throughput: 580 Mbps (site-to-site, single tunnel)
Max Sessions: 1,000,000 concurrent
New Sessions/sec: 71,000 (listed under general capacity; not specific to VPN or IPsec)
Interfaces: 2x 2.5GbE RJ45, 2x 25G SFP28, 2x 10G SFP+ (some listings show 2x RJ45 + 4x SFP28; verify against the Ubiquiti datasheet)
Form Factor: 1U rack-mount, dual hot-swappable PSUs
SSL/TLS Inspection Concurrent Sessions: 10,000 (5,000 recommended under heavy traffic)
CPU / Memory: 18-core ARM v8.2 @ 2 GHz, 16 GB DDR4
UniFi Capacity: 500+ UniFi devices, 5,000+ clients

✔ Pros: 25G SFP28 and 10G SFP+ uplinks at a gateway price point; 23.5 Gbps routing throughput; 1 million concurrent sessions; 18-core ARM CPU with 16 GB RAM; hot-swappable redundant PSUs; supports 500+ UniFi devices and 5,000+ clients; manages through UniFi Network controller with a single pane of glass
✘ Cons: IPsec VPN throughput of 580 Mbps is low for a gateway at this price; IDS/IPS throughput of 12.5 Gbps halves routing performance when threat inspection is enabled; SSL/TLS inspection is limited to about 10,000 concurrent sessions; port configuration differs across listings and should be verified; frequently out of stock at major US retailers, with a $170 memory surcharge at some resellers; no built-in Wi-Fi, so it depends on separate UniFi APs and switches; reviewers cite a steeper learning curve than consumer-grade routers
Est. Price: $1,999 - $2,892

Juniper Networks SRX4600

★ 4.1 Value Score

Firewall Throughput: Up to 400 Gbps (1518B and IMIX, per Juniper HCT hardware specs). Older datasheet figures differ and should be checked against the current Junos release.
Threat Prevention Throughput: Not confirmed in verified sources. An older datasheet cites roughly 80-90 Gbps with application security enabled; treat as unverified.
IPsec VPN Throughput: 71 Gbps (1400B); 44 Gbps (IMIX)
Max Sessions: 60,000,000 (60M concurrent IPv4/IPv6 sessions)
New Sessions/sec: 500,000-600,000 (sources disagree; not confirmed on the current spec page)
Interfaces: 8x 10GbE SFP+; 4x QSFP28 (40/100GbE, channelizable); 4x SFP+ chassis cluster/HA ports; 1x RJ-45 console; 1x RJ-45 management; 1x USB Type A; timing ports (GNSS, 10 MHz, BITS, PPS, ToD)
IPsec Tunnels: 7,500
SSL Connections Per Second: 16,000
Form Factor: 1U fixed chassis (1.72 in / 4.37 cm height); 2x hot-swappable PSUs in 1+1 redundancy; front-to-back airflow; AC max 800 W, AC average 650 W; DC variant also available
PoE: Not applicable (security gateway, no PoE)

✔ Pros: Up to 400 Gbps rated firewall throughput in a 1U chassis; 4x QSFP28 ports allow 40/100GbE uplinks alongside 8x 10GbE; Dedicated SFP+ chassis cluster ports support active/passive HA; Very high concurrent session capacity (about 60M) and 7,500 IPsec tunnels; Redundant hot-swappable 1+1 power supplies with front-to-back airflow; Junos-based SRX platform with full security service options
✘ Cons: New units list at roughly $117,000-$211,000 before subscriptions, far above most SMB and mid-market needs; Threat prevention throughput is not clearly published, and the 400 Gbps figure is an up-to rating under Juniper's test conditions; Published new-connections-per-second and older AppSecure/IPsec figures conflict across sources; Advanced security subscriptions add substantial cost (one listing shows about $255,000 for a 7-year Advanced bundle); No PoE or wireless capability, so it serves only as a security gateway; Juniper's official spec pages redirected to HPE during research, so confirm current support and lifecycle status before purchase
Est. Price: $117,036 - $211,505

PACKETPERF